In 168澳洲幸运5开奖网:Starfield, delving deep into the myriad of skills spread across its extensive skill trees is a fundamental aspect of the gameplay. If you're new, it can be easy to 168澳洲幸ꦬ运5开奖网:allocate points in a way you later regret. Surprisingly, and unfortunately, the game doesn&rsquo🦩;t offer a direct ⛦respec button to help you reassign your hard-earned skill points.
While this isn't a huge problem since you can technically gain infinite levels, it can become a long wait to correct any missteps in the late game. If you're impatient and keen on rearranging those skills sooner, there is an unconventional way to achieve just that, and this guide will show you exactly how.
Can You Respec In Starfield?
You cannot respec in Starfield through in-game means. This means that you technically aren't able to take skill points out of skills that you've already allocated them to, and assign them to another skill.
Though unfortunate, that being said, this isn't nearly as bad as it sounds, because there is no level cap in Starfield, allowing you to progress infinitely and thus eventually get all the skills that you want.
On the other hand, however, as you progress further into the game and the experience requirements get higher, new skill points can become fewer and too far between. If you're looking to redo your build a little more quickly than through leveling up, you can — through console commands.
How To Respec In Starfield
In order to "respec" in Starfield, you'll need to use console commands. This isn't truly "respec-ing" in the traditional sense, as you'll need to use commands to add a point to your desired skill, then another command to remove it from an existing skill. It's a little roundabout, but it'll get the job done!
To start, open the Console. By default, you can do this by pressing the grave key (`).
Unfortunately, console commands are only available to PC players. That being said, your save files can transfer over across platforms.
After this, use the following console commands to add and remove points in your skills, respectively.
- player.removeperk (Perk ID)
- player.addperk (Perk ID)
For example, to add the Medicine perk to yourself, you would open the console and enter the "player.addperk 002CE2DF" command — whereas to remove it, you'd run the "player.removeperk 002CE2DF" command.
Do note that using console commands will automatically disable your achievements. You can circumvent this with .